Metals & Alloy

World´s first “middle-soft” milling of Co/Cr in 98mm – wet or dry! The blank is pre-sintered, so most delicate structures and minimal wall thicknesses can be realized. The blank does not contain binder anymore, so the sintering time is greatly reduced, resulting in less argon gas consumption. Also manufactured in isostatic high pressure process, same indications as the softer CopraSintec K. Very small wear of burs.

Soft as wax milling of Co/Cr – wet or dry! The isostatic high pressure manufacturing process allows bridges with up to 14 units and even implant bar restorations. Non precious metal alloy type 4, therefore no limitations compared to milled or cast Co/Cr alloys. The small shrinkage allows you to place up to 40 units in a blank. Minimal wear of burs.

Isostatic, powder-metallurgical manufactured hard Co/Cr blank

Optimum homogeneity due to isostatic high pressure manufacturing process. Minimal bur wear out due to extremely high homogeneity without “hard islands” and casting segregations as with common Co/Cr blanks. Higher milling speed due to better machinability (like titanium) and lower Vickers hardness. Up to 50% shorter process time in your milling system.

Titanium Blank of high-grade pure titanium (grade 4)

Guaranteed constant quality with extreme fine microstructure for the crowns- and bridge technique, as well as bar restorations and superstructures in the anterior- and posterior regions (range of indications depending on hardness grade). All ceramics for titanium are applicable.

Titanium Blank of high-grade titanium-aluminium alloy (grade 5)

Guaranteed constant quality with extreme fine microstructure for the crowns- and bridge technique, as well as bar restorations and superstructures in the anterior- and posterior regions (range of indications depending on hardness grade). All ceramics for titanium are applicable.

Test material for milling strategies (No medical device)